ASI 100% RTV Silicone (ASI 502) can be applied to surface temperatures from -18°C to +50°C (0°F to +120°F) and after curing, withstands constant operating temperatures from -70 to +400 degrees F.
Fitting
Flash Point
Float Switch
For Best Results
For Use On
Form Factor (LXT)
Fuel Oil Resistant
Full Cure
GFCI Plugs
Galvanized Steel Rail
Grinding Wheels
Grip Circumference
Grip Range
Grit
Gross Weight
Group
Guard Size
Heat Resistant Outsole
Height
Hose Size
Includes Dust Extraction Guard
Increment
Input Power (ampere)
Length
Lifting Capacity
Lifting with Eyelets
Load Capacity
Location
Lock-Off Switch
Lock-On Switch
Manually Telescopes
Material Boot Shaft
Material Color Matching Guide
Material Outsole
Max Feed Rate
Max Load When Fully Extended
Max RPM DRY
Max RPM WET
Max. Blade Size
Max. Cut Thickness @ 90°
Max. Cutting Capacity (at 45°)
Max. Cutting Capacity (at 90°)
Max. Free Speed
Max. Horse Power
Max. Wheel Diameter
Maximum Grip
Maximum RPM
Metatarsal Protection
Application Method
Min. Cut Thickness @ 90°
Minimum Grip
Mixing Ratio
Model
Motor Type
Net Weight
No Load Speed
Notes
ASI 502 (ASI 100% RTV Silicone) is permitted under regulations of the Food and Drug Administration where incidental food contact might be involved. FDA Regulation number is 175.105.
Number of Pads
Number of Wheels
Odor
Oil Resistant Outsole
Output Power
Overall Length
PH Measurement
Pad Diameter
Pad Size
Painting
ASI 502 sealant should not be applied to surfaces that will be painted. Painting over sealant is not recommended because the paint film does not stretch with the extension of the sealant.
Polishing Disc
Position
Post Wall Thickness
Power Source
Power Type
Priming
Priming for ASI 502 is not normally required for applications to nonporous surfaces.
Unprimed adhesion can be easily tested by applying a small trial bead and allowing 7 days for maximum adhesion to occur. If primer is required, contact ASI.
Processing Time
Profile
RPM Drill Press
RPM Hand Tool
Rack Height
Radius
Rated Capacity
Rated Input Power
Rectangular Hole
Rectangular Rubber Cap
Removal
Rubber Wheel
Safety Standard USA
Sanding Disc
Sanding Disc
Segment
Segment (W x H)
Segment Count
Segment Length
Segment Size
Service Temperature Range
Shape
Shelf Life
Size Options
Size Range US
Sleeve Size (W x L)
Soft Start
Sound Pressure
Specific Gravity
Specs
Speed at Rated Load
Spindle
Spindle Thread
Square Hole
Square Rubber Cap
Square Tube Post
Standard
Stationary With Casters
Steel Post Base
Steel Tube Post
Straps of Each Side
Suction Pad Dimension
Suggested Feed Rate
Support Plate Channels
Surface Preparation
All surfaces should be clean and dry. It is recommended that bonding surfaces be solvent wiped with naphthas, ketones or chlorinated solvents. Specific solvents would include xylol, toluol and mineral spirits.
In case of plastics, determine suitability of solvent prior to use. Allow surface to dry thoroughly before applying sealant. Do not solvent wipe with alcohols or oil-containing solvents such as Varsol.
